Windows 2000 – Syba SB-ATA8212-133R User Manual
Page 24
RAIDExpress 133 RAID USER MANUAL
43
3.
If there is a marking ! or ? before the RAIDExpress 133 ATA RAID Controller
device as shown below, it indicates that the driver has not been correctly
installed. Users should remove the device and reinstall.
RAIDExpress 133 RAID USER MANUAL
44
Windows 2000
Install the driver during Windows 2000 installation
1.
Start Windows 2000 installation.
Warning: Because of the different selections of the
following installation methods, the time when step2 starts
will be different.
n
Boot from floppy with Windows installation diskette.
n
Boot from floppy with un-installable diskette.
n
Boot from CD-ROM with Windows installation CD.
2.
When the message
“Press F6 if you need to install third party SCSI or
RAID driver
” appears on the bottom of the screen, please press the <F6> key.
3.
The installation will continue. When a message appears to ask you to
designate the device you want to install, press the <S> key.
4.
Follow the instruction of the installation program to insert the RAIDExpress 133
ATA RAID Controller Driver diskette into the floppy disk drive then press the
<Enter> key to continue.
5.
Select RAIDExpress 133 ATA RAID Controller (Windows 2000/XP) from the
device list shown on the window then press the <Enter> key to continue.
6.
The devices that are going to be installed will be listed on the next window.
RAIDExpress 133 ATA RAID Controller (Windows 2000/XP) should be
contained on the list. If you need to install any other devices, please designate
them now. After designating all the devices, please proceed to the next step.
7.
Press the <Enter> key to continue the installation of Windows 2000.
!