Titan neo, Titan neo components & operation – TeachLogic Titan Neo User Manual
Page 12
2
12
Titan Neo
Titan Neo COMPONENTS & OPERATION
DR-800 Auto Scan Receiver for Wireless Microphone
One or two auto scan receiver modules can be installed in the Titan Neo. Each
receiver has 96 selectable channels to assure interference-free operation and
is equipped with a diversity antenna for added sensitivity.
Operation
Auto Scan Receiver
1.
Turn receiver “on”, turning volume/power switch clockwise to 12 o’clock.
2.
The receiver will display the last channel previously selected.
3.
To scan for a clear channel push the “Scan” button. The LCD screen will
display “SCAn” while searching for first available open channel/frequency.
The receiver will lock on and display the cleanest available channel.
4.
Tune the transmitter frequency to match the displayed channel on the
receiver to begin operation.
Manual Tuning
1.
Press and hold the “Up or Down” selector until the channel number blinks.
2.
Press the “Up or Down” button until the desired channel is selected.
3.
The receiver will stop blinking and lock into the selected channel.
Continue Tuning
1.
The auto scan receiver is now ready to receive signal from a wireless
microphone for AirLink transmitter. Tune the transmitter frequency to match
the displayed channel on the receiver to begin operation.
2.
When receiving a transmission signal, the A/B diversity antenna LED will
illuminate “Red or Green” indicating antenna selection.
3.
RX indicator will illuminate “Blue”, indicating reception of signal from
transmitter.
4.
AF indicator will flash “Green” when receiving an audio signal.
LCD Display: Ch. # or Freq. Readout
RF Reception: Diversity A/B Antenna (Red or Green)
Transmission Signal Present Indicator (Blue)
Flashing - Audio Level Being Received
(Green)
Channel Scan
Channel “Up/Down” Selector
Receiver Module: “on/off” and Master Gain
1
2
3
4
5
6
7
2
1
3
6
4
7
5