TeachLogic Titan Neo - Manual (Page 18)

18
Titan Neo
Titan Neo COMPONENTS & OPERATION
Playing CD-800S
Playing SD/MMC Card
Playing USB Drive
• This player will accept 4.75” (12 cm) discs like CD, CD-R, CD-RW, MP3,
USB and SD / MMC memory cards, but will not play CD-ROM / CD-I / CDV,
or 3” (8 cm) discs.
• The CD player will accept MPEG-3 ( MP3 ) and WMA format files.
• Insert a disc into disc slot with the playback side down, playback starts
automatically. Track number and playing time will be displayed.
• To pause playback or start normal playback, press PLAY/PAUSE or press
on the remote controller.
• Press REV, F.WD, or on the remote controller, to select previous or
next track. CD player will continue playback while displaying selected track.
• To stop playback, press STOP/EJECT or press once on the remote
controller.
• To eject CD press STOP/EJECT once to stop playback. Press again to eject
CD. Or press on remote controller.
• Press FB, FF or on the remote controller, to activate fast back or
fast forward until desired selection is located.
• Press LO, NOR, HI/PITCH or on the remote controller to adjust
low, normal and high playback pitch.
• Press FOLDER or on the remote controller, will select the next cata-
logue of tracks to be played.
• Insert SD Card or MMC Card into the insert hole of SD/MMC CARD in the
face plate. Push the card into the SD/MMC card slot. To remove the card,
please push the card to the bottom and then release. Please do not use force
to pull card out. Pulling the card will damage the card and/or machine.
• Press SD/USB/CD or SD/USB/CD on the remote controller. Select SD then
press PLAY/PAUSE or on the remote controller to play.
• Insert USB into the insert hole of USB in the face plate.
• Press SD/USB/CD or SD/USB/CD on the remote controller.
• Select USB then press PLAY/PAUSE or on the remote controller to play.
USB Input will not accept audio from iPod, iPad or iPhone. You may connect an mp3 from the
device headphone jack to the Titan RCA inputs
LOW NOR HIGH
1. Pull battery clip
2. Insert battery
3. Replace clip