Gate reset loop, Figure 2. gate reset loop dimensions – Unitec CAME Wiring User Manual
Page 8
Advertising
would only be used in new construction (where concrete is not yet poured). Saw cut loops are
used in pre-existing concrete and installed in a rectangular groove that is cut into the concrete.
Refer to the loop installation instructions for detailed installation procedures.
Gate Reset Loop
Each gate requires one gate reset loop. The reset loop should be formed into a 6’ long by 3’ wide
rectangle and located as shown in Figure 2.
Figure 2. Gate Reset Loop Dimensions
Document
Number:
GC1004
4
Document Title:
Unitec CAME Gate and Gate Controller Installation Guide
Advertising