Canon SX6 - Manual (Page 109)

109
MAINT
ENANCE
Replacing the Lamp
1
Turn off the projector, disconnect the power
plug from the AC outlet, and then let the pro-
jector stand for at least 1 hour.
2
Loosen a screw with a flathead screwdriver
and remove the lamp cover.
3
Loosen two screws, pull up the handle, and
then remove the lamp.
4
Fully insert a new lamp and secure it with two
screws.
* After the installation, be sure to push down
the handle.
5
Replace the lamp cover and tighten the
screw.
6
Turn on the projector.
7
Bring up the menu and select [System set-
tings] -> [Other settings] -> [Lamp counter]
(P102).
8
Select [Reset] -> [OK] to reset the lamp
counter.
Lamp cover
Screw
Screw
Lamp
Handle
Lamp cover