Wildview STC-TGL-2IR User Manual
Page 11
STC-TGL2IR
www.wildviewcam.com Toll Free 888-304-6125
11
o
AVI: 10 second video clip per PIR triggering
•
FULL: When memory capacity is full, this front LCD
screen will show “FULL”
Programming your Wildview Camera
The following setting must be performed before you
turn on the camera.
1. Select the time out interval by sliding the time out
toggle switch to the desired preset time interval in
minutes. 1 / 5 / 10 / 20 minutes.
2. Select the resolution setting by sliding the resolution
toggle switch to the desired resolution setting. Hi /
Lo resolution.
3. Select the Infrared mode: Slide the switch to either
Auto / On / Off position.
a. Auto – Infrared LED on based on surround light
conditions.
b. On – Infrared LED on for every image captured
c. Off – No Infrared LED will go off.