Wildview STC-TGL-2IR - Manual (Page 13)

STC-TGL2IR
www.wildviewcam.com Toll Free 888-304-6125 13
h. Press and hold [SET] button for 2 seconds to exit
the setting mode and enter into PIR count down
mode. Display will show date and number of
picture taken.
Once the program setting has been completed, slide
the power switch to OFF position until you are ready
for field use.
NOTE: Date & Time setting will be lost whenever the
batteries are removed from camera. Don’t forget to re-
set the Date & Time stamp after you replace the batteries.