Winchester Repeating Arms 9410 Cross Bolt Safety (Historic Manual) - Manual (Page 17)

17
Whenever you are not actually firing your shotgun always
be certain that your gun is pointed in a safe direction.
Continually be aware of the position of the manual hammer
stop on your shotgun. Check it both manually and visually
to avoid any chance of accidental discharge. Always keep
the manual hammer stop in the “on” position unless you
are actually firing the shotgun. It is a good idea to keep
the action open (with the finger lever down) at all times
other than when you are in the field and shooting is
imminent.
IMPORTANT: IT IS ALWAYS RECOMMENDED
THAT THE ACTION BE KEPT OPEN AT ALL
TIMES WHEN YOUR SHOTGUN IS LAYING ON
ANY BENCH OR TABLE AT A SHOOTING
RANGE OR OTHER FACILITY. ALWAYS KEEP
THE MUZZLE OF YOUR SHOTGUN POINTED IN A
SAFE DIRECTION. FAILURE TO FOLLOW THE
ABOVE INSTRUCTIONS COULD RESULT IN
INJURY OR DEATH TO YOURSELF OR OTHERS.
A SSEMBLY / DISASSEMBLY
Your Model 9410 comes fully assembled in the box. No
assembly to the gun itself is required. No disassembly is
required for normal maintenance.
If your Model 9410 requires disassembly for any reason
(such as requiring extra cleaning after being dropped in
water) it should be performed by a competent gunsmith,
by one of our Authorized Repair Centers, or by our
service facility.
I NSTALLING A S COPE
Rifled slugs (Foster-type) in .410 bore can offer excellent
accuracy when used in your new shotgun. Consequently,
in some situations you may want the advantage of a scope
or dot type sight. Scope mounts are available separately.
General instructions for installing scope mounts are
outlined below. Most systems will be similar to the ones
explained here.
Be sure to also follow the instructions
provided with your mounts.
1. Remove the plug screws and de-grease the holes in the
top of the receiver.
Trigger Stop
Finger Lever
FIGURE 7
02-018_9410_Ownersmanual 8/14/02 11:23 AM Page 17