Winchester Repeating Arms 9410 Cross Bolt Safety (Historic Manual) - Manual (Page 29)

29
point the end of the magazine away from your face and in
a safe direction. Never look directly down into the cap
end of the open magazine.
ALWAYS WEAR EYE PROTECTION WHEN
REMOVING AND INSTALLING THE MAGAZINE’S
THREE-SHOT PLUG.
If you misplace or break the adapter included with your
Model 9410, contact our parts department (Page 34).
A DAPTER I NSTALLATION M ODEL 9410 T RADITIONAL —
1. Loosen and remove the magazine end cap retaining
screw located on the underside of the forward end of the
magazine tube (Figure 22).
2. Carefully remove the magazine end cap from the magazine.
Remember, it is under spring load.
3. The spring will rise out of the magazine tube.
4. Place the three shot adapter inside the magazine spring
coils with the flared end of the adapter resting on the top
coil. (Figure 23).
5. Replace the magazine end cap, pushing the spring and
adapter back down into the magazine tube.
6. Replace the magazine cap retaining screw.
A DAPTER R EMOVAL , M ODEL 9410 T RADITIONAL —
1. Loosen and remove the magazine end cap retaining
screw located on the underside of the forward end of the
magazine tube (Figure 22).
2. Carefully remove the magazine end cap from the magazine.
Remember, it is under spring load.
3. As the spring rises out of the magazine tube, it will lift
the three-shot adapter with it.
Remove magazine
end cap
3 shot adapter inside magazine
FIGURE 22 FIGURE 23
02-018_9410_Ownersmanual 8/14/02 11:23 AM Page 29