Winchester Repeating Arms 9410 Cross Bolt Safety (Historic Manual) - Manual (Page 30)

4. Remove the three-shot adapter from the spring
(Figure 23).
5. Replace the magazine end cap, pushing the spring back
down into the magazine tube.
6. Replace the magazine cap retaining screw.
A DAPTER I NSTALLATION M ODEL 9410 P ACKER —
1. Remove the two screws on the front of forearm cap
using a standard screwdriver.
2. Pass a small screwdriver through the hole in the sling
post found on the end of the magazine tube. Turn the post
counter clockwise to loosen the post. (Figure 24.)
3. Slide forearm cap forward on magazine tube. Carefully
remove the magazine end cap from the magazine by
tilting the magazine tube away from the barrel enough
to clear the sling post mounting stud on the barrel.
Remember, magazine is under spring load.
(Figure 25.)
4. The spring will rise out of the magazine tube. Place
the three shot adapter inside the magazine spring coils
with the flared end of the adapter resting on the top coil.
(Figure 23.)
5. Replace magazine end cap, pushing the spring and
adapter back down into the magazine tube. BE SURE
To install the end cap with the flat spot around the sling
post mounting stud hole facing away from the barrel.
(Figure 26.)
30
Tilt magazine tube away
from barrel while keeping
pressure on end cap.
Turn sling swivel stud
counterclockwise to
loosen.
FIGURE 24 FIGURE 25
02-018_9410_Ownersmanual 8/14/02 11:23 AM Page 30