ZPC 9107W - Manual (Page 4)

Pg 4 of 16
Arrows on
cams
should be
pointing
up.
7
1
A
4
D
T
4
7
2
7
A
6
H
Finished edge
Finished edge
Place the assembly upside-down so the cam holes in the
side panels are on top. Insert cams (H) into cam holes mak-
ing sure the arrows on the cams are pointing up.
Insert one metal dowel (T), by tapping with a hammer, into
the top hole on each end in one of the curved trim pieces
(4). Insert one short dowel (D) into the bottom hole in each
end of the same curved rail (4).
Attach the curved trim piece (4) to the left top panel (7), by
inserting the dowels (D,T) into the dowel holes.
Fasten right top panel (6) to the assembly, by inserting the
dowels (D,T) into the dowel holes and using large screws
(A).
5. 6.
3. 4.
2.
Insert 4 short dowels (D) into the holes in the middle fixed
shelf (2). Insert the short dowels (D) of the middle fixed shelf
(2) into the left top panel (7).
1.
Fasten the left top panel (7) to the top (1), using large
screws (A).
IS9178