ZPC 9107W - Manual (Page 7)

Pg 7 of 16
I
C
Bumpers
to be
placed
here.
J
Figure 1
L
A
Top of Unit
F
Not Provided
11
5
S
B
Fasten knobs (I) to doors (11) with knob screws (C). Place
the bumpers (M) on the doors (11) where they come in
contact with the adjustable shelf (10) and the middle fixed
shelf (2).
Position adjustable shelf (8) in desired location in cabinet
using shelf clips (G). See Figure 1. Apply screw caps (J)
to screws (A) on exterior of unit. See Figure 2. Apply cam
caps (L) to cams (H). See Figure 3.
Place unit in desired location, then install bottom support
rail (5) using four large screws (A). Do Not fasten the bot-
tom support rail to the back of the assembly until the
space saver is placed over the toilet. The bottom rail
may be adjusted using different holes in the bottom
side panel.
19.
21.
20.
Mounting Instructions
1. It is imperative that the unit be fastened the unit to the
wall for safety reasons. Warning: Before cutting or
drilling into any wall surface, verify the location of
electrical, plumbing and gas lines. Cutting any of these
may cause serious injury.
2. Fasten the nylon strap (S) to the top of the unit using
one washer (B) and the mounting screw (F) as shown.
Fasten the nylon strap (S) to the wall using the appropriate
mounting hardware (Not Provided). We recommend using
a mounting screw of at least two inches in length.
22.
G
Figure 2
Figure 3
Attach the hinges to the mounting brackets. For Hinge
Installation and Adjustments See Page 16.
18.
IS9178