ZPC 9107W - Manual (Page 6)

Pg 6 of 16
Do This!!
BOTH legs on floor
Avoid This!!
N
P
11
R
Q
Top
Assembly
Bottom
Assembly
Finished
edge
Fasten hinges (P) to the doors (11), using hinge screws
(N). DO NOT OVERTIGHTEN!
Carefully stand the unit up.
CAUTION:
To avoid breaking legs, ONLY stand up unit while BOTH
legs support weight.
DO NOT stand up unit while ONLY one leg supports
weight.
16.
14.
15.
17.
Fasten mounting brackets for hinges (Q) to the inside of
the cabinet, using mounting bracket screws (R), making
sure the long sides of the mounting brackets are facing the
front of the assembly.
Carefully place bottom assembly on top assembly, by lining
up dowels (E) and cambolts (O) with holes. Turn each cam
(H) clockwise approximately a quarter of a turn. Then,
tighten each cam, by turning clockwise until tight. DO NOT
OVERTIGHTEN!
13.
Place entire unit flat with back of unit facing up. Align the
back panel (12) with the top and sides, finished side facing
down. Attach back panel (12) to the unit with nails (K) provid-
ed.
Helpful Hint: Attach nails in the corners of the cabinet back first
to help you align it with the top and sides.
12
IS9178