ZPC 9107W - Manual (Page 5)

Pg 5 of 16
Arrows on cams
should be pointing up.
E
O
7
3
6
4
9
A
4
8
A
5
A
8
9
Finished
edge
Finished
edge
Unfinished
edge
Finished
edge
11. 12.
9. 10.
7.
Insert cambolts (O) into the middle holes and long dowels
(E) into the four remaining holes of the top side panels (6,7).
Fit the bottom fixed shelf (3) over the assembly as shown.
NOTE: This is the top assembly.
Attach the curved trim piece (4) to the left bottom panel (9),
by inserting the dowel (D) and using a large screw (A). Attach the right bottom panel (8) to the curved trim piece
(4), by inserting the dowel (D) and using a large screw (A).
Insert the two remaining cams (H) into the bottom side
panels (8,9) with arrows pointing up. Attach 1 support rail (5) to the bottom side panels, using
large screws (A). NOTE: This is the bottom assembly.
4
D
8.
Insert one short dowel (D) into the bottom hole in each end
of the remaining curved trim piece (4).
IS9178