LaMotte DO 6 Dissolved Oxygen Meter - Manual (Page 12)

3.6 Switching the Meter On
When switching the meter on, it will go through a series of display, eventually
showing the revision number of the meter before going to the measurement
mode. The mode of measurement which the meter displays will be similar to
the last measurement mode to
which the meter is switched off.
Press ON/OFF key to power up
your meter.
1. All LCD segments will light up
for 1.5 seconds.
2. The display will then
momentarily show the meter’s
identification “DO 6” with the
annunciators for percentage
saturation mode and
concentration mode.
3. The display continues to switch
to display meter’s revision
number for 1.5 seconds before
finally showing the
measurement mode.
4. Either percentage saturation
measurement mode,
concentration measurement
mode or temperature
measurement mode will be
displayed following the previous
measurement mode to which
the meter is switched off.
Figure7: Power Up sequence
11
CAL 13 CAL 24 TAvg
A
1.00
10.00
D06
mg/L
NTU
mg/L
ppm
ppm
% pH
%
%
+
- 8.8.8.8
ON
OFF