ClearOne MUR2EM Installation Guide - Manual (Page 14)

Musica MUR2EM
3-2 NS-1005-7140
All specifications subject to change without notification. All rights reserved. Copyright © 2005 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Hardware Requirements
To complete an installation including more than one MUR2EM, you will need:
 a Musica MU5066ADC (part number NS-MU5066ADC).
NOTE: You’ll need two ADCs for an 18-zone implementation.
 an MUR2EM (part number NS-MUR2EM ) f or each ADC,
 a hub/switch,
 a computer with serial port (or USB to serial adapter),
 an Ethernet cable for each MUR2EM,
 an RS-232 cable for each MUR2EM,
 a power cable for each MUR2EM,
 a power cable for each Musica MU5066ADC,
 power cable for the hub/switch.
Software Requirements
 Macromedia Flash running on the web browser device.
 Windows XP, SP2.
 a Flash-compatible web browser.
Configuring the IP Address
To configure the IP address for all MUR2EMs on the system, you must first connect
the hardware, then use HyperTerminal to complete the configuration.
Connecting the MUR2EM
To connect additional MUR2EMs and ADCs, complete the following steps:
1. Connect each MUR2EM to the computer using the null modem cable provided.
NOTE: If your computer does not have a serial port, you need to use an adapter that
converts from USB to serial. Note the COM port number.
2. Connect the Ethernet port of each MUR2EM to the network hub/switch.
3. Connect the Ethernet port of the computer to the network hub/switch.
4. Ensure all power cables are plugged in.
5. Start the computer.
Using HyperTerminal
This section shows you how to configure the IP address for each MUR2EM in a 12-18
zone system to work with your PC, wireless web tablet, or PDA and the NetStreams
MU5066ADC.