ClearOne MUR2EM Installation Guide - Manual (Page 17)

Connecting Multiple MUR2EMs
NS-1005-7140 3-5
All specifications subject to change without notification. All rights reserved. Copyright © 2005 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Figure 3-5 Blank HyperTerminal screen
8. Pull the power cable from the first of your MUR2EMs, wait 5 seconds, then plug it
back in.
Wait 30-60 seconds while HyperTerminal connects to the MUR2EM. Shortly, the
screen displays information for the NetStreams MUR2EM and says you can make
changes if you press any key within five seconds of the information displaying.
9. Press any key.
You are prompted to Accept or Modify the settings.
10. Enter M to modify.
You are prompted for the root password.
11. Enter Netsilicon (the field is case-sensitive).
You are prompted to enter your IP settings.
NOTE: These will typically be settings from the PC you are using with the MUR2E.
12. Enter the Static IP Address and press Enter.
NOTE: If you have more than one MUR2EM, the IP addresses must be sequential. For
instance, the first MUR2EM might be 10.15.100.150, and the next two would
be 10.15.100.151 and 10.15.100.152.
You are prompted to enter the Subnet mask.
13. Enter the Subnet Mask and press Enter.
You are prompted to enter the Gateway Address.
14. Enter the Gateway address and press Enter.
You are prompted that changes are being saved in NV memory and that the
configuration is done (see Figure 3-6).