Great Plains NTA3010 Operator Manual - Manual (Page 21)

19
Section 2 Operating Instructions
8/14/ NTA3010 and NTA3510 Air Drill Implement SN Z1370- 160-219M
Great Plains Mfg., Inc.
Warning Lights. To use the implement warning lights,
your tractor must be equipped with a seven-pin electrical
connector. Always use implement warning lights when
transporting the air drill.
Watch Traffic. Remember that the cart bins and folded
implement wings can obstruct your view. Be prepared for
sudden maneuvers from following vehicles.
Marker Attachments. If you have installed optional mark-
er attachments, refer to the manufacturer’s instructions for
closing the marker hydraulic valves for safe transport.
NOTE: Failure to close marker hydraulic valves during
transportation could result in equipment or property dam-
age.
Parking
Perform the following steps when parking the drill. Refer to
Storage, “Maintenance and Lubrication,” page 28, for in-
formation on long-term storage preparation.
1. Raise the implement and install transport locks as ex-
plained under Lifting the Implement, page 14.
2. Park implement on a firm, level area.
3. Securely block the tires to prevent rolling.
4. Unhook electrical lines.
5. Release pressure on the hydraulic system, then dis-
connect hydraulic lines. Check that hose ends do not
rest on the ground.