10hd opener maintenance, 10hd disk spreader-scraper, 20 series opener maintenance – Great Plains 3N-4020 Operator Manual User Manual

Page 116: 20 series side gauge wheels

Advertising
background image

112

3N-4010F/3N-4010HDF/3N-4020F

Table of Contents

Index

Great Plains Manufacturing, Inc.

196-359M

Table of Contents

Index

2013-10-29

10HD Opener Maintenance

10HD Disk Spreader-Scraper
Refer to Figure 159

To perform this inspection (and replacement), it may be
necessary to remove one or both opener disk blades.

1.

With unit raised, remove bolt

holding on one or

both blades.

Note: Keep the spacer washers

on the outside of the

disk on the bolt. Do not misplace the spacers

on

the insider of the disk. They control disk-to-disk
contact.

2.

Check blade spreader

for wear. Replace spreader

assembly if the lower section

ahead of the seed

tube bracket is

1

2

in (13mm) thick or narrower.

3.

To replace, remove seed tube

, drive out roll pins

and install new spreader.

4.

When reinstalling disk blades, put spacers back on in
same order as removed.

Note: It is normal for blade spreader to have some loose-

ness in the holder and between the blades. Some
looseness is required for proper operation.

20 Series Opener Maintenance

20 Series Side Gauge Wheels
Refer to Figure 160

1.

Lift opener side wheel

off the ground. Move tire in

and out to check for end play. Check for roughness in
bearing by rotating wheel. If the bearings are rough,
inspect and replace if necessary.

2.

Check for the correct number of flat washers

and

machine washer

between the side gauge wheel

and the wheel arm

. There must be three flat

washers

and one machine washer

between the

wheel bearing and arm with the machine washer
next to the arm. There should be three flat washers

and one lock washer

on the outside of the

wheel. When installed, the wheel should turn freely
and not hit the arm at the curve. Do not add any
more washers than necessary.

3.

Disassemble side-gauge-wheel arm from unit.
Remove bushing

from sleeve

and check bush-

ing for wear. Replace bushing if necessary.

4.

When reinstalling side gauge wheels, align tab on
hex adjustment

with notch in bushing. Replace

bolt and tighten.

Figure 159

10HD Spreader/Scraper

27228

3

2

1

4

5

6

7

1

2

3

4

5

6

7

1

2

.eps

45%

Figure 160

20 Series Side Depth Wheel

20432

3

2

4

5

6

7

8

9

1

2

3

1

4

2

3

3

2

5

6

7

8

Advertising
This manual is related to the following products: