Great Plains ADC2250 Operator Manual - Manual (Page 10)

8
Introduction
Model 2250 Air Drill Cart 167-033M 7/28/10
Great Plains Mfg., Inc.
Using This Manual
This Operator’s Section is designed to help familiarize you
with safety, assembly, operation, adjustments, trouble-
shooting, and maintenance. Read this manual and follow
the recommendations to help ensure safe and efficient op-
eration.
The warranty sheet should be filled out by the owner and
dealer at the time of purchase. After completion give the
dealer the white copy and send the pink copy to Great
Plains. Keep your copy in the manual for use when corre-
sponding with the dealer.
To order a new Operator or Parts Manual contact your au-
thorized dealer or write to the address listed below in the
Owner Assistance paragraph. Include the model and seri-
al numbers of your unit.
The information contained within this manual was current
at the time of printing. Some parts may change slightly to
assure you of the best performance.
Terminology:
"Right " or "Left" as used in this manual is determined by
facing the direction the machine will travel while in use un-
less otherwise stated.
Definitions:
IMPORTANT: Information, related to it’s proceeding topic,
that the author feels would be of use.
Owner Assistance
If customer service or repair parts are required contact
your local Great Plains Dealer. He has trained personnel,
repair parts, and the equipment needed to service your
implement.
These parts have been specially designed and should
only be replaced with genuine Great Plains parts.
Serial Number Plate
NOTE: A special point of information related to it’s
preceding topic. The author’s intention is that you
read and note this information before continuing.
Refer to Figure 1 for the location of your serial number plates.
For prompt service always use the serial number and
model number when ordering parts from your Great Plains
Dealer. Be sure to include your serial and model numbers
in correspondence also.
Your dealer wants you to be satisfied with your new ma-
chine. If for any reason you do not understand any part of
this manual or are not satisfied with the service received,
the following actions are suggested:
1. Discuss the matter with your dealership Service Man-
ager make sure he is aware of any problems you may
have and that he has had the opportunity to assist you.
2. If you are still not satisfied or do not understand any
part of this manual seek out the Owner or General
Manager of the dealership, explain the problem and
request assistance.
3. For further assistance write to:
Product Support
Great Plains Mfg. Inc., Service Department
P.O. Box 245
Assaria, Ks. 67416
11130
Serial Number Plate Location
Figure 1