Amico Dome Loaded Manifold Nema-4 NFPA - Manual (Page 13)

www.amico.com 13
Wall Mounting Instructions
1. Remove manifold control panel from the shipping carton and ensure it is in upright position on the foam
packaging insert.
2.
Using the back support bracket as a template, place on the flat wall, align top of the bracket with the level
horizontal line. The vertical center line of the bracket will be the vertical center line of the installed manifold. The
support bracket should be mounted 61 1/2” [1,562.1 mm] from the finished floor to the bottom hole on the
bracket as shown in fi gure 1).
3. Mark locations of mounting holes. Remove the bracket and drill mounting holes. Attach the bracket to the wall
with appropriate anchors (supplied by others). 3/8” [9.525 mm] diameter anchors are recommended.
Figure 1
To Floor
Locate bracket per
horizontal line
61 1/2”
[1,562.1mm]
Mark Location
of holes