B&G Network Quad User Manual
Page 30
CALIBRATING THE TEMPERATURE SENSOR
Temperature calibration should only be carried out when the
built-in sea water temperature sensor (part of the speed
sensor) is considered to be inaccurate. The temperature of
the water will have to be measured with an accurate
temperature sensing device, this value can then be entered
into the Network QUAD unit.
In the following example the unit is displaying a reading of
10.4°C, the water temperature is known to be 11.4°C. The
correct value is entered into the Network QUAD unit.
Press TEMP key
until TEMP °C is
displayed.
Press SETUP key
twice to display
CAL °C .
Press ENTER if
required to
change the
displayed value.
The display will
flash.
Use
S or T keys
to change the
displayed value.
Press ENTER key
to memorise the
new value.
Press TEMP key
to display sea
temperature.
610-HB-0503-05
30