Baseline Systems BaseStation 3200 - Manual (Page 11)

Baseline Wi-Fi Module Configuration Guide
9
6. Remove the Wi-Fi module from the cabinet and unscrew the cover from the end where the
Ethernet cable is plugged in. The gasket will pop out. Be sure to set it aside so you can reuse
it.
7. Reconnect the antenna cable, the power cable, and the Ethernet cable.
8. Power on the controller.
9. Use a pointed object to press and hold the Reset button until all the lights flash, and then
release the button.
10. Reattach the connector cover and replace the gasket.
11. Reattach the Wi-Fi module mounting plate inside the cabinet.
12. Replace the control board cover.
13. Follow the instructions in the previous sections of this document to reconfigure the Wi-Fi
module.