Baseline Systems BaseStation 3200 - Manual (Page 9)

Baseline Wi-Fi Module Configuration Guide
7
18. To verify that the Wi-Fi module is connected to the network, click the Main tab. Review the
Signal Strength meter. When the Wi-Fi module is receiving a strong signal, the meter shows
cyan colored indicators at the right end of the bar.
19. When you are satisfied that the Wi-Fi module settings are accurate, close the browser tab or
window where the airOS application is displayed.
20. Disconnect the Ethernet cable from your computer and reconnect it to BaseStation 3200
controller’s Ethernet port.
Note: If you need to reset the Wi-Fi module to its factory settings, refer to the instructions at
the end of this document.
Step 4 – Return the computer to the previous settings
Go back through the steps in the Step 2 section to access the IP properties settings. Change the
settings as indicated below:
Microsoft Windows: Click Obtain an IP address automatically.
Macintosh: Select Using DHCP from the from the Configure pop-up menu.