BlueAnt Supertooth 3 Handsfree - Manual (Page 21)

21
EN
TROUBLESHOOTING
1. How do I re-connect my Supertooth 3?
Switch the Supertooth 3 on by pressing the MFB and it will
automatically connect to your phone. If the Supertooth 3
doesn’t automatically connect, simply press the MFB once. If
pressing the MFB starts voice dialling on your phone, simply
press the MFB a 2nd time to cancel voice dialling.
2. Why won’t my Supertooth 3 go into pairing mode?
Follow the instructions in the Supertooth 3 Manual. From off,
press and hold the MFB until the LED starts flashing red and
blue and you are prompted to select your preferred language.
Once you have selected your preferred language follow the
voice prompts to pair your Supertooth 3 to your phone.
The Supertooth 3 sometimes requires a few seconds to
establish a connection.
Please be patient while devices are searching.
3. Is my Supertooth 3 Charged?
When the battery is charged the LED will flash blue. When
the battery is low the blue flashing LED will be replaced
with a steady red LED and the Supertooth 3 will announce
“Low Battery”
4. Why can’t I hear any sound from the Speaker?
Check to make sure that both the Supertooth 3 and phone
volume are not set too low. Alternatively, the phone’s memory
may have become corrupt and can be fixed by re-booting the
phone (turning the phone off and on again). If this does not
resolve the issue delete the pairing information and re-pair.
5. Why does my Supertooth 3 sound noisy and distorted?
Turn your mobile phone and Supertooth 3 volume down to
a level that does not give echo or feedback. A low battery
can also cause bad voice quality. If low battery is indicated,
please charge the headset. Some people like to have
their phone ring loudly, but this may cause distortion when
transferred to the Supertooth 3 speaker. In your phone, set
up a Profile with lower ringing volumes and keypad tones