BlueAnt Supertooth 3 Handsfree - Manual (Page 4)

4
C. Charging
1. Connect the charger’s plug into the Charger Port (9)
of the SUPERTOOTH 3. Connect the charger to an
external power source.
Charge Indicator (4) Status:
Steady red: Low Battery Speech: Low Battery
Steady orange: Charging Speech: Charging
Steady green: Full Charge Speech: Fully Charged
2. When the Supertooth 3 is fully charged,
disconnect the charger.
D. Power On/Off
Power On: Press MFB (1) for 1 second. The Bluetooth
Indicator (3) will turn blinking blue and a voice will say,
“SUPERTOOTH 3 ready. Connected to phone (or if
phone not available: No phone detected).”
Note: The fi rst time the SUPERTOOTH 3 is switched on, the
language selection is automatically activated. In this case,
proceed to Section E (Procedure 2).
Power Off: Press and hold MFB (1) for 5 seconds until
a voice announces, “SUPERTOOTH 3 powering
down.” The Bluetooth Indicator (3) will turn a steady
red for 4 seconds, the device will then switch off.