Colorlight CL20 - Manual (Page 33)

INSTALLATION MANUAL CL20 Page 33
SWITCH ON LIGHT 14.
The searchlight is equipped with two halogen bulbs, the light can be turned on by pressing (2) or
(5), Both lights will be lit with a slight delay in between, no matter which button is used. To turn
off the light, press button (2) or (5) again.
There are however occasions when it may be useful to give each bulb a dedicated light button,
this setting is done in the "Single lamp mode" menu, please see
User’s Manual, section
11.8.6.5
Single lamp mode.
There is a bulb warning feature in the system. This warning can be chosen by the operator to be
shown or not by switch on or off the function in the settings menu, please see
User’s Manual,
section 11.8.4 Lamp life.
Note:
Halogen bulbs provide no status feedback to the Ebox and therefore the light function must be
visually verified to ensure that the bulbs light up.
This warning feature will show a white triangle symbol when the estimated bulblife left is
less than 200 hours. The symbol will be shown at the displays bottom left or right corner
according to left or right bulb
When the expected lifetime is expired the white triangle will change to a red triangle.
The only way to reset this symbol is by entering the “lamp life” menu at the diagnostic
display inside the electrical box. To get to the correct menu use the three buttons below
the display. Under the lamp life menu there are two choices: “usage statistics” and “reset
counters
”. Select “reset counters” and select the corresponding lamp housing for which the
counter should be reset. Certainly this reset should only be done together with a bulb
replacement!