Colorlight CL20 - Manual (Page 5)

INSTALLATION MANUAL CL20 Page 5
WARNINGS AND INFORMATION 1.
High voltage!
Before opening any part of the searchlight system, make sure all power is switched
off!
Halogen bulbs
Make sure the bulb is properly installed into socket to obtain good electrical
contact and to avoid damaging bulb and/or socket.
To avoid damage to bulb, do not twist. Pull old lamp straight out and push new
bulb straight in.
Never bump, drop, apply excessive stress, or scratch the bulb. This could cause
the bulb to burst! Do not operate any bulbs with any traces of scratches, cracks, or
physical damage
Always transport the bulb in the provided protective case or cover until installation!
Save the protective case or cover and packaging materials (box) for bulbs that
have been used to their rated service life. Use the protective case when disposing
of the bulbs.
Always use safety glasses when installing or removing the bulbs.
When changing bulbs be sure to not touch the surface of the bulbs with bare
fingers. If inadvertently touched with bare fingers it should be degreased
immediately with alcohol and a soft lint free cloth. Be sure to wipe dry the bulb
surface afterwards.
Never touch the bulb when it is on, or soon after it has been turned off, as it is hot
and will cause serious burns. Bulbs should be allowed to cool for a minimum of ten
(10) minutes after the light is turned off.
The light should never under any circumstances be turned on without frontglass.
Reflectors
The parabolic reflectors developed by ColorLight have an extremely smooth
surface to focus the light in wide or narrow beam. Bare fingers should never touch
the reflector surface. If inadvertently touched, the reflector surface should
immediately be degreased with alcohol and a soft lint free cloth.