Colorlight CL25 Installation manual - Manual (Page 24)

Page 24 INSTALLATION MANUAL CL25, CL35
Electrical box installation 8.4
Tools and supplies required:
1 Screwdriver 0,6×3,5 mm
2 Adjustable wrench type Bacho 8071
3 Wrench 13 mm
4
Important information
The complete system is undergoing final testing before delivery and therefore has the
searchlight cables installed in box.
1. Ensure that the switch Q01in box is set to off.
2. Remove all the cables in the terminals, the terminals are push-in type and the wire is
released easily by pressing the orange button with a screwdriver while pulling lightly in
the wire.
3. Loosen the cable glands with an adjustable wrench and pull out the cables.
4. Mount the electric box on a firm foundation with the help of the wall brackets.
5. Install in reverse order and pay special attention so that the cables shields are mounted
correct in the cable glands, see figure 2 below for guidance.
Cables are connected according to the wiring diagram and double-checked before the
power is turned on using the main switch Q01 in the electric box.
1 Electrical box 1 Shield Connection