Colorlight CL25 Installation manual - Manual (Page 28)

Page 28 INSTALLATION MANUAL CL25, CL35
DISPLAY SYMBOLS AND MESSAGES 10.
Symbol for switched off white light.
Symbol for switched on white light.
Error symbol for white light indicates a problem during switch on or if the bulb
breaks down during operation. The operator has three switch-on attempts in a two
minute interval without setting the sum alarm output.
Symbol for switched off UV light (black light).
Symbol for switched on UV light (black light).
Error symbol for UV light indicates a problem during switch on or if the bulb breaks
down during operation. The operator has three switch-on attempts in a two minute
interval without setting the sum alarm output.
Symbol for any electro-mechanic error. Might be referred as an over voltage or
over current for motor drivers. Communication error with motor drivers will result in
the same symbol. This error symbol can be reset by simply enter the main menu
and select status. Then press “dismiss”. If over current have occurred the problem
might be referred as a stucked lamp housing
– check for any icing issues. Each
axis has its own symbol showing in upper left or right corner of the display.