Colorlight CL25 Installation manual - Manual (Page 8)

Page 8 INSTALLATION MANUAL CL25, CL35
WARRANTY CONDITIONS 2.
A correctly installed searchlight system from ColorLight requires no planned regular
maintenance or service during the first 10 years in operation (except changing the bulbs after
they are used up).
The
“Maintenance and Service plan” describes how to keep the product in good condition.
The warranty is conditioned by below mentioned key points.
Before powering up the unit, make sure that:
 Vibration dampers are mounted correctly according to user’s manual.
 The mechanical fundament where the searchlight is placed is robust.
 Warranty seal on the service hatch is unbroken.
 Outgoing cable radius from the searchlight is smooth and not stressed.

All cables used for the installations are as per ColorLight’s specifications or as per
separate made agreement.
 Signal cables are not placed together with high power cables.
 Electrical connections are made according to electrical scheme and wiring diagram.
 Length of cables are not exceeding the recommended maximum lengths as stated
below:

Power cables between searchlight and E-box for 230 VAC-system: Max 30 meter

Power cables between searchlight and E-box for 24 VDC-system: Max 5 meter

Remote cable / Ethernet cable between E-box and remote control: Max 100 meter
(longer distance requires an amplifier or fibre optic version).
 E-box (EB) is placed in an non-condense environment with a minimum temperature of
+5 C (indoor) if not customised for other installation.
 The remote panel (OP) is bridge mounted in an IP54 environment. If placed outside it
must be under a protection hood when not in use.
 Remote panel is screwed in bridge panel, properly grounded and correct installed.
After above checkpoints are verified the system should be started up as per User’s
Manual to verify the functionalities.
In case of any questions related to the warranty, please contact us at
[email protected] for
additional support.