Bissell 7901J - Manual (Page 17)

17
Remove the black brush arm that holds the brush in place.
Set the black brush arm aside (see illustration).
Remove the “toothed” Brush Belt from the brush then from
the red pump pulley. Set the “toothed” Brush Belt and
brush aside.
Locate and remove broken Pump Belt.
With the unit still on its side, loop one end of the
replacement Pump Belt around the red pump pulley and
then the other end around the silver motor shaft (see
illustration). Do not twist the replacement Pump Belt.
Re-install the “toothed” Brush Belt first onto the red pump pulley
and then onto the “toothed” end of the brush (see illustration).
Re-install the brush into the base of unit.
Place the black brush arm onto the brush and slide black
brush arm into base of unit. The black brush arm and brush
should slide easily into original position (see illustration).
Re-install the red retainer plate and Phillips head screw
(see illustration).
Using your finger, gently spin the replacement Pump Belt on
the silver motor shaft. If assembled correctly, the replacement
Pump Belt should rotate freely around the silver motor shaft
and drive pulley without obstruction. The brush should also
rotate freely when the silver motor shaft is turned.
Turn the machine right side up and replace the Tank-In-Tank,
SmartMix Bottle and Belt Access Door (see illustration).
Assembly is now complete.
If you have any questions, or are having trouble installing
your replacement Pump Belt, please call BISSELL
Consumer Services in the UK at 0870-225-0109. For
all other countries call our USA Headquarters at
01-616-453-4451. Or visit the BISSELL website at www.
bissell.com.
Pump Belt Replacement Continued
7.
8.
9.
7 8
9
To Install the Replacement Pump Belt
1.
2.
3.
4.
5.
6.
7.
8.
1
2
4
5
6
7a
7b