Bissell 7901J - Manual (Page 9)

Remove Tank Lid by rotating handle forward to unlatch
lid and lifting lid off Tank.
Pour out dirty water.
After each use, remove and rinse the Lint Screen located
on the tank lid.
A. Remove Tank Assembly from unit.
B. Remove Tank Lid.
C. Remove any debris caught in Lint Screen.
D. Re-insert Lint Screen on Tank Lid. The screen will
click into place
E. Replace Tank Lid.
F. Re-insert Tank Assembly into unit.
Refill with clean hand hot tap water, following steps 5
through 9 on page 8, and refill the SmartMix Bottle with
BISSELL Advanced Deep Cleaning Formula
as necessary.
When the cleaning job is complete, rinse out the
Tank-in-Tank by rinsing clean water between the Bladder
and Tank.
Return Tank-in-Tank to the machine, following steps 6
through 9 on page 8.
Refer to the Maintenance section on pages 15-16 for
the final cleanup.
The Flow Indicator is located on the machine base. It spins when the
trigger is pressed to indicate that the machine is applying
cleaning solution to the floor. It will stop spinning to indicate that the
SmartMix Bottle or Bladder needs to be refilled, or when the trigger
is released.
Note: Flow Indicator does not spin when set to
Tools/PreTreat setting.
This provides above floor cleaning with the flip of a switch.
Just choose the cleaning tool, attach to the Flex Hose and
ProHeat II is ready to clean upholstery, stairs and more.*
*Set the ReadyTools Dial to Floor Cleaning when
cleaning carpets or bare floors or set it to Tools/
PreTreat when using the Flex Hose attachments
or for pre-treating floors.
SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
9
When It’s Time to Empty Tank-in-Tank Continued
3.
4.
5.
6.
7.
8.
9.
3
5D
Rotate Handle to
unlatch
Tip:
Thorough
vacuuming
before deep
cleaning will
prevent early
clogging of
Lint Screen.
Tip:
A special red float
device in the Tank
will cause the clean-
er to stop removing
solution from the
carpet and the
motor sound will
rise in pitch to
let you know the
dirty water tank
is full.
Fill bladder
only with clean
hand hot tap
water
The Flow Indicator
ReadyTools Dial
TOOLS PRETREA T
FLOOR CLEANING
Flow Indicator
ReadyTools Dial
5C Lint Screen
Pour out
dirty water 4
6
Latched
8