Bissell 7901J - Manual (Page 6)

6
Special Features of your BISSELL ProHeat™ II
The ProHeat II is a home cleaning system that automatically mixes
hand hot tap water with BISSELL Advanced Deep Cleaning Formula
and heats the solution as it is applied to the carpet. The combination
of heated cleaning solution, powered brush and suction provide a
safe and effective method of cleaning.
Temperature control automatically heats the cleaning solution
as it is being applied to the carpet (*) to safely optimize
cleaning effectiveness.
The Power Switch controls the power to the machine and
the SmartTemp feature.
*SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
The SmartTemp Ready Light indicates the heater is ON. It
is found on the front of the handle where it is easy to see
while you clean. Wait two minutes for the heater to warm
up before beginning to clean.
SmartTemp increases the water temperature approximately
25° and will not allow it to exceed 180°.
Provides custom control for each cleaning job.
Lift the SmartMix Bottle up and out of the
machine base.
Turn the SmartMix Bottle over so that the Valve Cap is in
an upward position. Unscrew the Valve Cap and fill the
SmartMix Bottle to the mark with BISSELL Advanced Deep
Cleaning Formula.
Replace the Valve Cap, turning until snug.
SmartTemp™
1.
2.
3.
ON OFF
Power Switch
ON
OFF
SmartMix
Bottle
The BISSELL SmartClean™ System
SmartMix™
1.
2.
3.
SmartTemp Ready Light
Valve Cap