Bissell 7901J - Manual (Page 7)

7
SmartMix™ Continued
Replace SmartMix Bottle.
Choose the SmartMix setting that fits the cleaning job.
Water Rinse- use for gentle cleaning or for the
final rinse after cleaning.
Normal- automatically provides the best mix of
water and cleaning solution for most cleaning jobs.
High Traffic- automatically mixes the right amount
of water and cleaning solution to dissolve tough
grime and heavy soil. Note: Residual cleaning
materials left in carpet from other products may
cause excessive foaming when picked up. If foam
is overflowing Tank, move SmartMix Dial to “Water
Rinse” position until the condition stops.
Note: Both the SmartMix Bottle and the clean
water Tank must have liquid in them in
order for the machine to spray. If one is
empty, the machine will temporarily lose
its prime and will not spray cleaning
solution or water.
Important: If you are using the WATER RINSE
setting, fill the SmartMix Bottle with
water also!
The powered brush roll at the Floor Nozzle is designed to
enhance cleaning performance. The bristle pattern lifts out
the deep down dirt while gently grooming carpet fibres. The
floating suspension self-adjusts to all carpet heights. When
the machine handle is in the fully upright position, Carpet
Saver™ automatically raises the brush off the carpet and
protects your carpet if you leave the Power Switch ON.
4.
5.
Tip:
Deep cleaning
stairs and high
traffic areas on a
regular basis
can prolong
carpet life.
DirtLifter™ PowerBrush
WARNING:
To reduce the risk of
fire, use only BISSELL
Advanced Deep Cleaning
Formula for full size
machines in your ProHeat
II. Use of cleaning
formulas which contain
lemon or pine oil may
damage this appliance
and void the warranty.
Chemical spot cleaners or
solvent based soil remov-
ers should not be used.
These products may react
with the plastic materi-
als used in your ProHeat II,
causing cracking or pitting.
SmartMix
Dial
HIGH TRAFFIC
W ATER RINSE NORMAL