Chicago Electric 90401 User Manual
Page 10
SKU 90401
PAGE 10
2.
To attach the Halogen Lamp to a wall, first select the desired wall location on
which the Halogen Lamp will be mounted. IMPORTANT: Make sure that behind
the wall is a wall stud which will offer a stronger, more secure mounting
surface for the Halogen Lamp. (See Figure D.)
3.
Use the two holes in the Mounting Bracket (part #5) as a template to mark where
two 3/8” diameter holes will be drilled in through the wall and into the wall stud.
(See Figure D.)
4.
Once the two 3/8” diameter holes are drilled through the wall and into the wall
stud, attach the Mounting Bracket (part #5) to the wall and its wall stud, using two
3/8” diameter by 3-1/2” long wood bolts (not included). (See Figure D.)
5.
Attach the two Tubes (part #1) to the Mounting Bracket (part #5) as shown in the
illustration. (See Figure D.)
WALL
STUD
WALL
MOUNTING
BRACKET
(#5)
WOOD BOLT
(NOT INCLUDED)
BOLT
(#9)
PIPE
(#3)
TUBE
(#1)
TUBE
(#1)
WASHER (#7)
WASHER (#7)
MIDDLE PIPE (#4)
WASHER (#7)
LOCK NUT (#8)
FIGURE D
6.
Attach the Middle Tube (part #2) to the two Tubes (part #1) as shown in the
illustration. (See Figure E, next page.)
7.
Attach the Halogen Light (part #13) as shown in the illustration.
(See Figure F, next page.)
8.
Once the Halogen Lamp is fully assembled, you may aim the Lamp by loosening
the phillips Screw on each side of the Lamp. Tilt the Lamp to the desired posi-
tion. Then, re-tighten the phillips Screws. (See Figure G, next page.)
90401.p65
8/15/2003, 9:37 AM
10