FORD 2014 Expedition v.2 - Manual (Page 113)

SETUP
OIL LIFE
UNITS ENG /
METRIC press and hold
the
SELECT/RESET
stem English or Metric
AUTOLAMP 0 to 180 seconds
AUTOLOCK On or Off
AUTOUNLOCK On or Off
TRAILER SWAY
(if equipped) On or Off
TBC MODE Electric or EOH
CREATE MYKEY / MYKEY SETUP / CLEAR MYKEY
LANGUAGE =
ENGLISH /
SPANISH /
FRENCH press and hold
the
SELECT/RESET
stem English / Spanish / French
• HOLD RESET FOR SYSTEM CHECK: The message center will begin to
cycle through the vehicle systems and provide a status of the item if
needed. Some systems show a message only if a condition is present.
• OIL LIFE: This displays the remaining oil life. An oil change is
required whenever indicated by the message center and according to
the recommended maintenance schedule. USE ONLY
RECOMMENDED ENGINE OILS.
To reset the oil monitoring system to 100% after each oil change,
perform the following:
1. Press and release the SETUP button to display “OIL LIFE XXX%
HOLD RESET = NEW”.
2. Press and hold the RESET button for two seconds and release to reset
the oil life to 100%.
Note: To change oil life 100% value (if equipped with this feature) to
another value, proceed to Step 3.
3. Once “OIL LIFE SET TO XXX%” is displayed, release and press the
RESET button to change the Oil Life Start Value. Each release and press
will reduce the value by 10%.
• UNITS ENG / METRIC: Displays the current units in English or Metric.
• AUTOLAMP: This feature keeps your headlights on for up to three
minutes after the ignition is switched off.
112 Information Displays
2014 Expedition (exd)
Owners Guide gf, 2nd Printing, November 2013
USA (fus)