FORD 2013 C-MAX Hybrid v.1 - Manual (Page 153)

Make sure that the 120–volt convenience
cord is completely unwound before
charging. Always plug the cord into the AC
outlet before connecting the charging
coupler into the vehicle’s charge port
receptacle. The 120–volt convenience cord
inline control box has three indicator lights
that represent the charging status; power,
charge and fault.
Power (green light)— this indicator lights
up when the cord is plugged into the AC
wall outlet.
Charge (green light)— indicates status
of charging:
• No light means the cord is not
connected to the vehicle.
• Blinking light means that the charging
is in process.
• Solid light means that the vehicle is
connected but not charging.
Fault (red triangle light)— Lights up in
case of a detected failure. No charging is
possible:
• Blinking red triangle light – means that
the 120–volt convenience cord is trying
to reset the failure and could restart
the charging cycle.
• Solid red triangle light – means that
the fault is permanent. The cord needs
to be unplugged and re-plugged to
reset the fault. If the fault persists,
contact your authorized dealer.
Charge Port
The charge port is located between the
front left side door and front left wheel
well. There is an indentation located on
the charge port door. Press in and release
with your thumb to open and close the
door.
E144779
Note: Do not force the charge port door
open or closed. Forcing the door open or
closed will damage the charge port.
The light ring located around the charge
port indicates the charge status of your
vehicle's high-voltage battery. The charge
port light ring is divided into four quadrants
which display state of charge in 25 percent
increments.
There is a cord acknowledgment feature
that will be activated when a charge cycle
is initiated. The four light quadrants will
each individually flash clockwise starting
with the top right light and ending with the
top left, two full times confirming a
charging coupler has been detected.
You can use your keyfob to view the
vehicles charge status at any time by
pressing the unlock button. The light ring
will light up the corresponding quadrant(s)
so that the current state of charge can be
determined. If the charge is below 25
percent the light ring will not illuminate.
Don’t forget to press the lock button on
your keyfob to re-lock the vehicle.
The light ring will also display the current
state of charge when opening the doors.
Charging
Note: The vehicle must be in P (Park) to
charge.
To charge your high-voltage battery:
150
High Voltage Battery