FORD 2012 Explorer v.1 - Manual (Page 42)

Keys and Intelligent
Access Messages
Action / Description
NO KEY DETECTED Displayed if the intelligent access key is not
detected by the system in the following three
scenarios:
•When the start/stop button is pressed in an
attempt to either start the engine or cycle
through the ignition states.
•When the engine is running and a door is
opened then closed.
•When the vehicle’s speed exceeds 10 mph
(16 km/h) for the first time after starting.
Refer to Push button start system in the
Driving chapter for more information.
KEY PROGRAMMED
3 KEYS TOTAL Displayed during spare key programming,
when a third intelligent access key is
programmed to the system.
KEY PROGRAMMED
4 KEYS TOTAL Displayed during spare key programming,
when a fourth intelligent access key is
programmed to the system.
MAX NUMBER OF
KEYS LEARNED Displayed during spare key programming when
the maximum number of keys have been
programmed.
PRESS BRAKE TO
START Displayed when the start/stop button is
pressed without the brake pedal being applied.
This is a reminder that the brake pedal must
be applied when the start/stop button is
pressed in order to start the engine. Refer to
Push button start system in the Driving
chapter for more information.
RESTART NOW OR
KEY IS NEEDED Displayed when the start/stop button is
pressed to shut off the engine and a Intelligent
Access Key is not detected inside the vehicle.
Refer to Push button start system in the
Driving chapter for more information.
ACCESSORY
POWER ACTIVE Displayed when the vehicle is in the accessory
ignition state.
Instrument Cluster
42
2012 Explorer (exp)
Owners Guide, 1st Printing
USA (fus)