FORD 2012 F-150 Raptor v.2 - Manual (Page 118)

If the indicator light flashes rapidly for two seconds than turns to a
constant light, follow the steps
below.
Note: You may need a ladder to
reach the unit and you may need to
remove the cover or lamp lens.
1. Press the learn button on the
garage door opener motor.
Note: You will have 30 seconds to complete the next step.
2. Return to your car.
3. Press and hold the function
button for 2 seconds, then release.
Repeat this step. Depending on the
brand of garage door opener you
may do repeat this sequence a third
time.
To program additional buttons
repeat steps one through four.
For questions or comments, please contact HomeLink
௡ at
www.homelink.com or 1-800-355-3515.
Erasing the Function Button Codes
Note: You can not erase individual
buttons.
1. Press and hold the outer two
function buttons simultaneously for
approximately 20 seconds until the
indicator lights above the buttons
flash rapidly.
2. When the indicator lights flash,
release the buttons. The codes for
all buttons are erased.
Reprogramming a single button
To program a device to a previously trained button, follow these steps:
1. Press and hold the desired button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.
Driver Controls
118
2012 F-150 (f12)
Owners Guide, 2nd Printing
USA (fus)