FORD 2012 F-150 Raptor v.2 - Manual (Page 122)

Programming HomeLink ா to the Genie Intellicodeா 2 powerhead
Note: You may need a ladder to access the garage door opener
powerhead unit.
To put the Genie IC2 powerhead in program mode you will need to
access the program button. The program button is a square button
located on the garage door opener powerhead unit.
To program HomeLink
௡ to the powerhead
1. Press and hold the program button on the Genie IC2 Powerhead until
both blue LED’s turn on.
2. Release the program button. Only the smaller round LED should be
on.
3. Press and release the program button. The larger purple LED should
now be flashing
Note: The next 2 steps must be completed in 30 seconds.
4. Press and release the Genie IC2 transmitter’s previously programmed
button. Both LED’s on the powerhead unit should now flash purple.
5. Press and hold the previously programmed HomeLink
௡ button for
2 seconds. Repeat this step up to 3 times until the garage door moves.
At this point HomeLink
௡ programming is complete.
Clearing a HomeLink
ா device
To erase programming from the three HomeLink
௡ buttons press and hold
the two outer HomeLink
௡ buttons until the indicator light begins to flash.
The led will begin flashing in 10 to 20 seconds, at which time both
buttons should be released. Programming has now been erased, and the
led should blink slowly to indicate the device is in train mode when any
of the three HomeLink buttons are pressed.
FCC and RSS-210 Industry Canada Compliance
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications to your device not expressly approved by the
party responsible for compliance can void the user’s authority to operate
the equipment.
Driver Controls
122
2012 F-150 (f12)
Owners Guide, 2nd Printing
USA (fus)