Locking the doors, Car finder, Sounding a panic alarm – FORD 2010 Crown Victoria v.1 User Manual

Page 81: Opening the trunk, Replacing the battery, Locks and security

Advertising
background image

Locking the doors

Press

once to lock all the doors. Upon the first press the doors will

lock and the parklamps/taillamps will flash once.

Press

again within three seconds to receive confirmation that the

vehicle was successfully locked. Note: If all vehicle doors and the trunk
are closed upon the second press of the

, the horn will chirp once

and the parklamps/taillamps will flash once to confirm the successful
locking.

Upon the second press of the

, if any door or the trunk is not

securely closed the horn will chirp twice to warn that successfully
locking was not complete. The park/taillamps will not flash if any door is
ajar.

Car finder

Press

twice within three seconds. The horn will chirp and the

parklamps/tail lamps will flash. It is recommended that this method be
used to locate your vehicle, rather than using the panic alarm.

Sounding a panic alarm

Press

on the remote transmitter to activate the alarm.

Note: The panic alarm only works with the ignition in the off position.

Press

a second time to deactivate the alarm. You may also deactivate

the alarm by turning the ignition to the on position.

Opening the trunk

Press

once to open the trunk.

• Ensure that the trunk is closed and latched before driving your

vehicle. Failure to properly latch the trunk may cause objects to fall
out or block the driver’s rear view.

This feature will not work with a vehicle speed greater than 3 mph
(5 km/h) if the ignition is in the accessory or on position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.

Locks and Security

81

2010 Crown Victoria (cro)
Owners Guide, 1st Printing
USA
(fus)

Advertising