FORD 2010 Flex v.2 - Manual (Page 128)

Note: For all vehicles with remote start installed, it is possible to
program all original vehicle keys as MyKeys™, in which case, you will
need to use your remote start system to reset all MyKeys™ as admin
keys by doing the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your remote start fob.
3. Follow Steps 1-4 in the Disable MyKey™ section.
Troubleshooting
Condition Potential Causes
Can’t create a MyKey™
• Key in the ignition is already a MyKey™
• Key in the ignition is the last remaining
admin key (there always has to be at least
one admin key)
• SecuriLock௡ Passive Anti-Theft System is
disabled or in unlimited mode
• Vehicle has been started using a remote
start system that is programmed as MyKey™.
Refer to Using MyKey™ with remote start
systems section.
Cannot program the
MyKey™ optional
settings
• Key in the ignition is a MyKey™
• No MyKeys™ are programmed to the
vehicle. Refer to Create a MyKey™ section
• Vehicle has been started using a remote
start system that is programmed as MyKey™.
Refer to Using MyKey™ with remote start
systems section.
Cannot disable MyKey™
• Key in the ignition is a MyKey™
• No MyKeys™ are programmed to the
vehicle. Refer to Create a MyKey™ section
• Vehicle has been started using a remote
start system that is programmed as MyKey™.
Refer to Using MyKey™ with remote start
systems section.
Lost the only admin key
• Purchase a new key from your authorized
dealer
Lost any key
• For programming spare keys, refer to the
Programming spare keys section in this
chapter.
Locks and Security
128
2010 Flex (471)
Owners Guide, 2nd Printing
USA (fus)