Casio WK6500E1A - Manual (Page 42)

Using the Mixer
E-40
1.
Press the C-5 (MIXER) button.
• This causes the mixer screen to appear.
2. Use the R-17 (u, i) buttons to select the
mixer parameter you want to change.
• You can select master (MASTER), effect (DSP),
microphone input (MIC/INST), or a part (A01 through
A16, B01 through B16). The currently selected setting
is shown in the line two of the display.
• While a part is selected, you can toggle between
Group A and Group B by pressing both of the R-17 (u,
i) buttons at the same time.
3. Use the R-17 (t, y) buttons to move the thick
brackets (%) to the parameter you want to
change.
• The parameters that can be configured depend on the
currently selected setting. For details, refer to the
sections shown in the table below.
• When you move the thick brackets (%) to one of the
setting values of a part parameter, all of the part
parameter values of the group (A or B) to which the part
belongs are indicated by level meter black boxes.
4. Use the dial or R-14 (–, +) buttons to change the
setting value.
• Pressing the R-14 (–, +) buttons at the same time
returns a parameter to its initial default setting.
• While the “Part” (part on/off) setting of a part parameter
is being configured, pressing both of the R-14 (–, +)
buttons at the same time will change the setting to “Sol”
(Solo). For details, see “Part Parameters” (page E-44).
5.
Repeat steps 2 through 4 as required to
configure other parameters.
6. To exit the mixer, press the C-5 (MIXER) button
or the R-15 (EXIT) button.
• This exits the mixer screen.
• While master (MASTER), effect (DSP) or microphone input
(MIC/INST) is selected in step 2 above, setting, you also
can perform normal keyboard play (play using layer, split,
and Auto Accompaniment).
• While an individual part (A01 through A16, B01 through
B16) is selected in step 2 above, pressing a keyboard key
will sound only notes of the selected part. All other types of
performance operations (layer, split, Auto Accompaniment,
etc.) are disabled.
Mixer Operation
To change mixer parameters
Currently selected setting
(MASTER, DSP, MIC/INST, or A01 to A16/B01 to B16)
Parameter/Setting value
Currently selected setting part
(when currently selected setting is A01 to A16/B01 to B16)
When this setting is
selected:
These parameters can be
configured:
MASTER MASTER parameters
(page E-42)
MIC/INST MIC/INST parameters
(page E-43)
DSP DSP parameters (page E-42)
A01 to A16/B01 to B16 Part parameters (page E-44)
CTK6000_e.book 40 ページ ２０１０年７月１２日 月曜日 午後１２時５０分