Tone parameter settings, E-48 – Casio WK6500E1A User Manual

Page 50

Advertising
background image

Using the Tone Editor

E-48

The table below shows the parameters that can be configured on the tone editor screen. For information about each parameter,
also refer to “Tone Creation Overview” (page E-45).
The settings marked with an asterisk (

*) in the “Setting Range” column are initial defaults.

Tone Parameter Settings

Parameter Name

Description

Setting Range

AttackTime
(Attack Time)

Specifies the time until a note starts to sound after a key is pressed.

–64 to 0

*

to +63

ReleasTime
(Release Time)

Specifies the time a note continues to sound after a key is released.

–64 to 0

*

to +63

CutOff
(Cutoff Frequency)

Adjusts timbre by attenuating note components that are higher than a certain
frequency. A larger value produces a brighter, harder sound, while a lower
value produces a mellower, softer sound.

–64 to 0

*

to +63

Vib.Type
(Vibrato Type)

Specifies the vibrato type (vibrato waveform).

Sin

*

, Tri, Saw, Sqr

Vib.Depth
(Vibrato Depth)

Specifies how much vibrato is applied to a note.

–64 to 0

*

to +63

Vib.Rate
(Vibrato Rate)

Specifies the speed of the vibrato applied to a note.

–64 to 0

*

to +63

Vib.Delay
(Vibrato Delay)

Specifies how much time elapses until vibrato starts.

–64 to 0

*

to +63

Oct.Shift
(Octave Shift)

Shifts the pitch upwards or downwards in octave steps.

–2 to 0

*

to +2

Volume
(Volume)

Specifies the volume level of all tones. A larger value sets a higher volume
level.

0 to 127

*

TouchSense
(Touch Sense)

Specifies how much the volume changes in accordance with the relative
amount of pressure applied to keyboard keys. A larger positive value results
more change in volume in accordance with key pressure. A larger negative
values results in less change in volume in accordance with key pressure. Key
pressure does not affect volume when a value of 0 is set.

–64 to 0 to +63

*

Rev.Send
(Reverb Send)

Specifies how much reverb is applied for each tone.

0 to 40

*

to 127

Cho.Send
(Chorus Send)

Specifies how much chorus is applied for each tone.

0

*

to 127

Setting

Description

Waveform

Sin

Sine wave

Tri

Triangle wave

Saw

Sawtooth wave

Sqr

Square wave

CTK6000_e.book 48 ページ 2010年7月12日 月曜日 午後12時50分

Advertising
This manual is related to the following products: