Gate operator & canadian programming, Operating the homelink wireless control system, Driver controls – FORD 2006 F-150 v.2 User Manual

Page 83

Advertising
background image

Gate Operator & Canadian Programming

During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink

௡ to accept the signal

from the hand-held transmitter.

After completing Steps 1 and 2
outlined in the “Programming”
section, replace Step 3 with the following:

Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note Step 3 in the

“Programming” section) while you press and release — every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with Step 4 in the “Programming” section.

Operating the HomeLink

Wireless Control System

To operate, simply press and release
the appropriate HomeLink

௡ button.

Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink

௡ at www.homelink.com or

1–800–355–3515.

2006 F-150 (f12)
Owners Guide (post-2002-fmt)
USA
(fus)

Driver Controls

83

Advertising