FORD 2002 Explorer v.2 - Manual (Page 102)

JOBNAME: T14191ExplOG-US PAGE: 102 SESS: 12 OUTPUT: Tue Aug 26 14:27:29 2014
/restores/ford/ownguide/14191e-exp/og
HOMELINK ா UNIVERSAL TRANSCEIVER (IF EQUIPPED)
The HomeLink
௡ Universal Transceiver, located on the overhead console,
provides a convenient way to replace up to three hand-held transmitters
with a single built-in device. This feature will learn the radio frequency
codes of most current transmitters to operate garage doors, entry gates,
security systems, entry door locks, and home or office lighting.
When programming your HomeLink
௡ Universal Transceiver, to a
garage door or gate be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLink
௡ Universal Transceiver with any garage door
opener that lacks safety stop and reverse features as required by U.S.
federal safety standards (this includes any garage door opener model
manufactured before April 1, 1982). A garage door which cannot detect
an object, signaling the door to stop and reverse, does not meet current
U.S. federal safety standards. For more information on this matter, call
toll-free: 1–800–355–3515 or on the Internet at HomeLink.jci.com.
Programming
Do not program the HomeLink
௡ Universal Transceiver with the
vehicle parked in the garage.
1. Prepare for programming the
HomeLink
௡ Universal Transceiver by
erasing the three factory default
codes by holding down the two
outside buttons until the red light
begins to flash after 20 seconds.
Release both buttons.
2. Hold the end of your hand-held
transmitter 5–14 cm (2–5 inches)
away from the HomeLink
௡ Universal
Transceiver surface (located on your overhead console) while keeping
the red light in view.
Controls and features
102