Canon LV-7275 EN - Manual (Page 13)


❸ Part Names of the Projector
Zoom lever
(see page 30 )
Controls
(see page
6 )
lens
lens Cover
Be sure to remove the lens cover dur-
ing projection. the cap can deform or
fire can occur.
Built-in security slot ( )*
focus ring
(see page 30 )
adjustable tilt foot lock Button
(see page
29 )
adjustable tilt foot
(see page
29 )
remote sensor
(see page 9 )
Ventilation (inlet) / filter Cover
(see page
67 )
do not block this vent.
troubles or fire can result.
Front/Top
aC input
Connect the supplied power cord’s two-pin plug here, and
plug the other end into an active wall outlet. (see page
23 )
Main Power switch
When you plug the supplied power cord into an
active wall outlet and turn on the Main Power, the
POWer indicator turns orange and the projector
is in standby mode.
(see page
24 )
terminal Panel
(see page 6 )
Monaural speaker (7W)
Rear
* This security slot supports the MicroSaver ® Security System.
Ventilation (outlet)
heated air is exhausted from here.
do not block this vent. troubles
or fire can result.
. Introducton
lamp Cover
(see page
68 )
Carrying handle
rear foot
spacer (black rubber)
a spacer is provided for leveling the projector.
to fine-adjust the height of the rear foot,
remove the spacer and rotate the rear
foot to the desired height.
Ventilation (inlet) / filter Cover
(see page
67 )
do not block this vent.
troubles or fire can result.