Canon LV-7275 EN - Manual (Page 36)

7
. Projectng an Image (Basc Operaton)
Selecting Default Source
You can set a source as the default source so that it will be displayed each time the projector is turned on.
1. Press the MENU button.
the menu will be displayed.
2. Press the button twice to select [Setup] and press the button or the OK button to select [General].
3. Press the button four times to select [Options (2)].
4. Press the button six times to select [Default Source Select] and press the OK button.
the [default source select] screen will be displayed. see page 63 .
5. Select a source as the default source, and press the OK button.
6. Press the BACK button a few times to close the menu.
7. Restart the projector.
the source you selected in step 5 will be projected.
TIP: When the projector is in Standby mode, applying a computer signal from a computer connected to the ANALOG IN-1 input
will power on the projector and simultaneously project the computer’s image. ([Direct power on (Comp1)] See page 63 .)