Canon LV-7275 EN - Manual (Page 30)


. Installaton and Connectons
Connecting a Digital Video Signal
To project a source from audio video equipment with a digital video output such as an HDMI or DVI connector,
use a commercially available HDMI-to-DVI cable or the optional DVI digital cable to connect the Computer 2 input
[DIGITAL IN/ANALOG IN-2] connector of the projector as shown below.
To output the sound in stereo, connect to audio equipment.
AUDIO IN
L R
AUDIO OUT
L R
VIDEO OUT HDMI OUT
S-VIDEO VIDEO
AUDIO OUT
L R
VIDEO OUT
S-VIDEO VIDEO
DVI OUT
DIGITAL IN/
ANALOG IN-2
AUDIO IN
audio cable (not supplied)
audio video equipment
dVi digital cable
(Optional: lV-Ca29)
hdMi-to-dVi cable
(not supplied)
dVi connector
hdMi connector
• Select the input name for its appropriate input connector after turning on the projector.
Input connector
Use the INPUT button on the projector cabinet or the remote
control to select the appropriate input from the menu.
DIGITAL IN /
ANALOG IN-2
Computer 2 (Digital)
NOTE: An image may not be displayed depending on the specifications of the audio video equipment being used.
TIP: For users of audio video equipment with an HDMI connector:
Select “Enhanced” rather than “Normal” if HDMI output is switchable between “Enhanced” and “Normal”.
This will provide improved image contrast and more detailed dark areas.
For more information on settings, refer to the instruction manual of the audio video equipment to be connected.